For a commercial building, an HVAC failure is not a comfort problem. It is a business problem. Customers leave, employees cannot work, inventory is at risk, and in some facilities there are compliance implications.
Fall is when equipment that sat in cooling mode all summer gets asked to heat, and that transition is where failures surface. Fall commercial HVAC maintenance is how you find them first. Here is what to handle before it does.
Most commercial buildings in this area run packaged rooftop units, and they take more abuse than residential equipment because they live entirely outdoors. This part of the RTU maintenance checklist covers the cabinet, the roof connection and the heat section.
Cabinet and panel condition. Corrosion, missing screws, panels loosened by wind. A panel that is not sealed lets weather in and conditioned air out.
Curb and roof penetrations. Where the unit meets the roof is where leaks start. Check the curb seal and the flashing around every penetration before winter.
Coils. Condenser coils collect a summer’s worth of debris. Clean coils matter for efficiency and for compressor life going into next cooling season.
Belts and bearings. Many commercial units are belt driven. Check tension, alignment and wear. Belts are cheap; a broken one on a Monday morning is not.
Heat section. Burners, heat exchanger, ignition system and flue — the same combustion safety principles as residential, on equipment that works harder. The carbon monoxide risks apply just as much in an occupied commercial space.
Filters. Commercial filter racks are larger and easier to neglect. Set the schedule by environment, not by calendar.
Condensate. Drain pans and lines clear, with proper pitch and no standing water.
This one gets its own section because economizers fail quietly and constantly.
An economizer brings in outdoor air for free cooling when conditions allow. When the damper sticks, it either draws outside air when it should not — driving winter heating costs up sharply — or refuses to bring it in when free cooling is available.
Check the actuator, the linkage and the sensors at every commercial HVAC maintenance visit. A failed economizer is one of the most common sources of wasted energy in commercial buildings, and it is invisible on a bill unless someone goes looking. ENERGY STAR’s energy-saving guidance for commercial buildings covers more of these low-cost operational fixes.
Restaurants, shops and manufacturing spaces have exhaust systems pulling large volumes of air out of the building. That air has to be replaced, and in winter it has to be heated.
Makeup air units need the same seasonal attention as the primary heating equipment, and they are frequently overlooked because nobody thinks of them as the HVAC system.
Building pressure matters more than most owners realize. A building under negative pressure pulls cold air in through every door and gap, makes exterior doors hard to open, and can cause backdrafting of combustion appliances. If your entry doors are hard to open or you get cold drafts at the entrance, pressure balance is worth measuring.
Verify the schedule matches actual operating hours. Buildings change. Hours shift, tenants come and go, and control schedules rarely get updated. Conditioning an empty building on a schedule set three years ago is money leaving continuously.
Check setpoints and deadbands. A narrow deadband between heating and cooling setpoints causes systems to fight each other within the same day in the same zone.
Confirm sensors read accurately. A drifted sensor produces a building that never feels right no matter what the setpoint says.
Test unoccupied setbacks and holiday schedules, especially before the end-of-year period when many buildings sit empty for stretches.
In multi-tenant and mixed-use buildings, complaints cluster in specific spaces, and it is usually the same spaces every year.
Corner units, spaces with large glass areas, and areas reconfigured without HVAC modification all show up. Getting airflow measured and balanced before the season saves the recurring call.
If a space has been built out or subdivided since the system was designed, the distribution may no longer match the layout. That is a design question, not a service call.
For commercial equipment, records earn their keep.
A log of readings from each visit lets you see trends. A compressor drawing progressively more amps across three visits is telling you something a single reading cannot. Filter change dates, belt replacements and refrigerant additions all belong in the same record.
Refrigerant tracking especially. A system that needs refrigerant every year has a leak, and topping it off indefinitely costs more than finding it. It is also one of the clearest signs it is time to replace commercial equipment.
The heat section on a rooftop unit has been idle since spring. Ignition components, gas valves and flue connections all get tested the first time they are asked to work. If that first time is a cold Monday when the building fills with people, the failure is expensive.
Testing heat during rooftop unit fall service in September means finding problems on a mild day, with parts available and a schedule that has room.
We employ HVAC design and engineering professionals and handle commercial HVAC maintenance, repair and replacement across Southwest Michigan, from single rooftop units to multi-tenant and mixed-use buildings. In over 50 years we have worked across a wide range of industries and facility types in this region.
Our diagnostic process is built around resolving issues in a single visit where possible, because downtime is the real cost in a commercial setting. More on our commercial HVAC services, and specific rooftop failures in rooftop unit problems.
Twice a year at minimum, before cooling season and before heating season. Restaurants, manufacturing and facilities with heavy filtration loads often need quarterly service.
A damper assembly that brings in outdoor air for free cooling when conditions allow. When it sticks, it either wastes energy heating unnecessary outside air in winter or gives up free cooling in shoulder seasons. Common and costly.
Yes. Multi-tenant and mixed-use buildings are among the facility types we regularly work with in the Battle Creek area.
Getting the building ready for winter? Call J&J at (269) 965-1627 or schedule commercial HVAC maintenance today.
9000 M-66 South • East Leroy, MI 49051
(269) 965-1627
Monday - Friday: 8:00am - 5:00pm