Heat Pump in Snow: What Michigan Owners Should Do Before and After a Storm

The first heavy snowfall of the year in Southwest Michigan brings the same question from almost every new owner: is a heat pump in snow okay to keep running, and does that outdoor unit need protecting?

Yes. A heat pump in snow keeps heating as long as air can move through the outdoor coil and meltwater can drain. Keep a foot or two clear around the unit, keep the top grille open, let the defrost cycle handle frost, and never chip at ice.

Below is the storm routine we recommend, step by step, and the signs that mean it is time to call a technician.

Why a Heat Pump in Snow Needs Room to Breathe

In heating mode, the outdoor unit pulls heat out of winter air. Its fan draws that air across the coil, and every section of fin buried in snow is surface the system can no longer use.

Less airflow means less heat delivered indoors, more frequent defrost and more time on backup heat. On a dual fuel system that shifts work to the furnace. On an all-electric system it shows up on the electric bill.

Modern equipment is built for this climate. ENERGY STAR notes that many air-source heat pumps deliver heating capacity and efficiency at low outdoor temperatures. What none of them can do is pull heat through a snowbank.

Light frost is a separate issue, and the system clears it on its own. Our guide to the heat pump defrost cycle covers what normal looks like. This article is about the snow and ice that defrost cannot fix.

1. Clear a Perimeter and a Path

After each snowfall, clear a foot or two of open space on every side of the unit, including the side facing the house, where drifts like to hide. A plastic shovel or a broom does the job. Work from the outside in so the blade never swings toward the coil.

Shovel a path to it as well. If checking on a heat pump in snow means wading through a knee-deep drift, it stops getting checked, and a Michigan winter is long.

2. Keep the Top Grille Open

Most residential heat pumps blow air straight up through a fan grille on top. Snow that settles there works like a lid. The fan pushes against it, airflow drops, and meltwater from the next defrost runs down into the coil and refreezes.

Brush the top clear with a soft broom. Do not lay plywood, a tarp or a summer air conditioner cover over a heat pump in snow season. Anything that blocks the discharge while the system is heating does more harm than the snow it keeps off.

3. Look Up at the Roofline

Check what sits above the unit. A heat pump under a roof edge with no gutter, or under a gutter that overflows, takes a steady drip on sunny afternoons. That water freezes on the top and inside the coil overnight, and a few days of it can build a sheet of ice.

Sliding snow and icicles are the other hazard. A slab coming off a steep or metal roof can bend the fan grille or flatten fins. A clean, working gutter or a small diverter above the unit helps, and relocating it is worth discussing whenever the system is replaced.

4. Keep Plowed and Blown Snow Away

Plenty of buried units are not buried by the storm. They are buried by a snowblower chute aimed at the side yard or a plow pile pushed up against the house.

Before the first big storm, decide where the snow goes and make sure it is nowhere near the outdoor unit. If someone else clears your driveway, show them where the heat pump is. A low, pale cabinet next to a snowbank is easy to miss, and a heat pump in snow that gets hit by a plow blade is a repair, not a cleanup.

5. Check the Height of the Stand

A heat pump in snow country should never sit flat on the ground. During defrost, meltwater drains out through the base. If the base sits in snow, that water has nowhere to go. It freezes into the bottom of the coil and builds upward.

That is why heat pumps here go on raised stands, risers or wall brackets that hold them above typical snow depth and leave a drainage path underneath. If yours sits low, or the stand has settled and tilted, ask about raising it at the next service visit.

Ductless outdoor units follow the same rules. Wall brackets keep them high, but make sure roof snow is not landing on them. The rest of their winter care is in our mini split maintenance guide.

6. Never Chip, Pound or Pour

Do not chip ice off the coil with a shovel, scraper or screwdriver. The fins are thin aluminum and the tubing behind them carries refrigerant under pressure. One slip can puncture it, and a refrigerant leak in January means a long, cold wait for a repair.

Do not pound on the cabinet to crack ice loose, and skip the kettle of hot water, which only refreezes. Once you restore airflow around the unit, light ice usually clears through normal defrost.

If the coil or fan stays encased in solid ice, switch the thermostat to emergency heat if your system has backup heat, and call. That keeps the house warm without forcing a frozen outdoor unit to keep running.

Homeowner shoveling snow beside the house, including clearing space for a heat pump in snow

7. Recheck After Lake-Effect and Drifting Snow

Lake-effect bands off Lake Michigan can bury one neighborhood while the next town sees flurries, and wind can drift snow against the downwind side of a house even on a modest snowfall. The National Weather Service office in Grand Rapids posts local forecasts and winter weather information, so you know when a check will be needed.

After each storm, give your heat pump in snow a few minutes of attention:

  • Clear the perimeter and brush off the top grille.
  • Look for an ice cap on top or a mound of ice forming underneath.
  • Confirm the outdoor fan runs when the house calls for heat. It pauses during defrost, which is normal.
  • Watch whether the thermostat shows backup heat for hours at a stretch.
  • On a dual fuel system, check the furnace intake and exhaust pipes too. Our furnace vent pipe guide shows what to look for.
Outdoor heat pump unit that needs open space around it, since a heat pump in snow cannot pull air

When a Snowbound Heat Pump Needs a Technician

Call when a heat pump in snow shows solid ice that does not clear, ice building up underneath the unit, an outdoor fan that will not turn, or backup heat running all day in weather it handled last year. Those usually point to a defrost control, a sensor, the refrigerant charge or drainage, not just snow.

J&J has served this region for over 50 years, and our heat pump service covers homes in Kalamazoo, Portage, Richland and the surrounding towns. A technician checks defrost operation, refrigerant performance, the stand and the drainage path, and you get clear pricing before any work begins.

If the unit keeps getting buried because of where it sits, we can talk through raising or relocating it. For what the equipment should handle on the coldest nights, see heat pumps in Michigan winters.

Heat Pump in Snow FAQs

Is it safe to run a heat pump in snow?

Yes. Heat pumps are designed to run outdoors all winter, and a heat pump in snow works normally as long as air can move through the coil and meltwater can drain. Keep a foot or two clear around it, keep the top grille open and let the defrost cycle handle ordinary frost.

Should I cover my heat pump in winter?

No. Unlike a summer-only air conditioner, a heat pump runs all winter, and a cover, tarp or board over the top blocks the air it needs to heat your home. If roof runoff or drifting snow keeps burying it, ask about a gutter fix, a taller stand or a better location.

How do I get ice off my heat pump?

Restore airflow first by clearing snow from around and on top of the unit, then give defrost time to work. Never chip, pound or pour hot water on it. If the coil stays encased in ice, switch to emergency heat if you have backup heat and schedule a service visit.

Heat pump buried or iced over? Call J&J at (269) 965-1627 or schedule a visit today.